C217F BMW Fault Code

Description:

Catalytic converters must be warm before they can work properly. On a cold start the PCM provides a rich mixture to keep the cold engine running.
All that extra fuel goes into the catalytic converter. But the exhaust isn't very hot, because, ah, the engine is pretty cold. GM has employed several strategies to fire up the catalytic converter quicker and reduce cold start emissions. One way is to use a secondary air pump that pumps outside air directly into the catalytic converter.

C217F Code Symptoms :

There are currently two main types of cylinder deactivation used today, depending on the type of engine. C217F code for the pushrod design which uses solenoids to alter the oil pressure delivered to the lifters. In their collapsed state, the lifters are unable to elevate their companion pushrods under the valve rocker arms, resulting in valves that cannot be actuated and remain closed.

Diagnosis And Repairing C217F

C217F OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

How to fix C217F code ?

• Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
• Intake Valve Timing Control Solenoid Valve circuit poor electrical connection
• Insufficient cylinders compression

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source.

Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.